I just walked by Kings Chapel grave yard and noticed that it runs up against some of the buildings on the side

update as I know this is a parking garage

Add outline of Longfellow Bridge, after taking a glance at how this was done for a bridge in London

update a building outline i had broken slightly

Add a surface parking lot

Change the outline of a recreational area to better match reality/ aerial photos

Break up a big building polygon

Realign Front of state house at 90 deg angles after my earlier mod

Aligning the state house grounds with the boundary of the state house

connect a way that was detected in mapright as not being connected. must have been an artificat of tiger import

not sure how to tag a covered bridge - used bridge=yes and covered_bridge=yes to start with, will put a note on the VT wiki page

Break up a few ways which were incorrectly tagged with bridge=yes and tag the correct portions as bridges

I figured out where Jenkins Brook Rd is - my brother knew

noticed a road that wasn't attached to any other road (they're less useful that way

split a way which had a different purpose on one side than the other. added a parking_aisle tag to the proper side

Update a few small roads here and there according to bing aerials

Update border of kings chapel burial ground based on aerial imagery

Update position of 54th memorial plus a couple of the walkways on the common. Also the Granary Burial Ground Boundary was off

make dickerman hill rd highway=unclassified, as I believe that is a much better classification than highway=residential

update the memorial tags a bit