shape detail, distinguishing obelisk from plinth, heights estimated

make building:part nodes consistent with building outline (join to entrance node and make that symmetrical in building). dome top detail tweaks

adjust dome top proportions and add detail. improve artwork statue height range to more plausible matching images

add uppermost floor and heights at est 3.5m/flr for office bldg 20 Old Bailey. Add and adjust a few details on courts building

better estimates of heights for building:parts of Central Criminal Courts building, from Mapbox-Esri parallax distances compared to 10 floor new office bldg opposite est 3.9m/flr=39m

drop height (=65) added to building at ch. 167437106 from a copyright source, and value likely applies to top? of statue above roof dome, not to any habitable/roof area of the building. current est heights on building parts are exceedingly low, to update

improve footway tagging through NEO Bankside: set default foot destination, with conditional permissive in daytime (was wrongly conditional no daytime) on N-S paths, diagonals are for flats access only. improve tagging on adjacent garden-roofed garage

reinstate building details on building. move business details onto a node

tidy building and roof edges to a grid of lines at mult of 45deg angs (6 deg fr N) so that roof skillion facets match better. tone down wall colour slightly

add conical roof areas as 12x quadrilateral skillions (W side x 5). Also add small glass areas on floors 1+2 on S corners from survey

adjust 3d building parts to combine adjacent flat areas with same height + colouring etc, with separate round roofs on top

add conical roof areas as 12x quadrilateral skillions (E side, mid and N)

reinstate intended glass walls on half round over white walls below

add conical roof area as 12x quadrilateral skillions (E side, S)

add/improve station towers detail. add riverside wall. mark removed 1 Swan La building as demolished. add missing building:colour

improve some small details of building on E side of station

add some 3d shape for Cannon St station and adjacent to E, from Cadastral-aligned Mapbox and external survey. Heights relative to 13flr office bldg est 43m, rest scaled from Esri-Mapbox parallax distances

improve some building and adjacent ways alignment to Cadastral-aligned Mapbox

connect steps to bridge to footway (extended) not to cycle-only cycleway. (Continue footways past mapped end of cycleways to already mapped crossing point)

improve cafe position relative to building (having corrected building position)