No response so feature removed.

Hi, regarding Way: 686353074 the tag incline=steep is not recognised by OSM. You need to have a value for incline as mentioned in this link :- incline=*

Regards Bernard.

Square up buildings, join unjoined building outlines

Square up, amend buildings and roads.

Square up and tag buildings, join unjoined building outlines, remove untagged features that I cannot see what they are.

Hi, There is so much obvious fiction (the prison, barn, slaughter house and other strange features) in this changeset that I think it best to revert it. So I've done so.

Please don't spoil OSM especially as you've made a lot of good contributions.

Regards Bernard.

Amended buildings, areas, barriers.

Amended road to track, joined track to road at south.

Deleted incorrect lines.

Hi I corrected your mapping.

Hi I corrected your mapping. Removed node, tagged building.

Hi, the company has applied to be voluntarily struck off the register of companies. Your contribution is not verifiable to OSM practice so I've removed the POI.

Hi, Part of Way: 691059362 now duplicates an existing way. It's OSM practice to amend the existing way.

Beg your pardon that should have been BLC FP7 (236291984) not joining the Park Meadow Close.

Hi, Way Meadhook Drive fails to join onto Park Meadow Close is this correct or should it join?

Regards Bernard.

Hi, Way BLC FP13 (617841426, v3) crosses over the A6 without a bridge or join.

Way: 696355197 does not join onto Meadhook Drive is that correct or inadvertent?

Regards Bernard.

Hi, Way BLC FP7 (236291984, v4) to the north passes over a service road with no join.

Hi I see you've amended the route of Way: BLC FP7 (236291984) to cross both carriageways of the A6. Unfortunately you have not joined the path to the A6, I take it that there is not a bridge or tunnel so the ways should be joined.

Also it is a PRoW footpath, so access is allowed as designated, access=no is not applicable so should be removed.

Regards Bernard.

Hi, Welcome to OpenStreetMap.

I see you've amended the footpath to go west through the woods. unfortunately you joined it to the boundary of the woods. Did you mean it to be joined to the track?

Regards Bernard.

Hi, The two paths one goes SE through the woods the other SE between blocks of woods. Click on the relevant way number below and open it in iD editor.

Place a point/node in the iD editor, type sculpture in the search the box and click on sculpture. You then have various attributes to add to that feature.

Regards Bernard.